Operation; Preparation - YILMAZ SC 550P User Manual

6.4 Ensure that the machine has been cleaned, tested and maintain before starting to operate.
6.5 Check the safety devices, power cable and moving parts regularly. Don't operate the machine before having
replaced defective safety devices or faulty parts.
6.6 Never replace the milling cutters before unplugging first.
6.7 Keep foreign materials away from the working area of the machine, keep away from the machine's moving parts
The safety data have been defined above. In order to prevent physical damage or damage to the
equipment, please read the safety information carefully and keep the manual always in an easy
accessible place.

7. OPERATION

7.1 Preparation

7.1.1 Degrease and dry the machine table. Especially ensure that the holding grips and handles are clean and dry
7.1.2 Clean all surfaces of the machine from chip and foreign particles. Use eye glasses for protection.
7.1.3 SC 550P cutting machines cut the products made of aluminium, wood and hard plastic materials that are not
ferroalloy. The operator adjusts the saw cutting progress according to the type and size of the material to be cut.
(Figure-9 No 19) the internal and external sharp edge ports of circular saw provides you to get rubbed surface in high
quality.
7.1.4 Control cutting tools against corrosion, distortion and fractions. If cutting tools are damaged, change them.
7.1.5 Cutting tool must process on the part after machine is operated and cycled..
7.1.6 Do not process the profile before clamping the work piece properly.
42