YILMAZ SC 550P User Manual page 26

7.2.6 Provide the vertical pneumatic clamps to tighten the part by using the clamp button on the machine (See
FIGURE 13)
7.2.7 Provide the saws to rotate by pressing the motor start buttons on the control panel..
7.2.8 Provide the saw to come forward by pressing simultaneously the double hands sefaty modul buttons and then
continue to press the buttons until the working part is cut.
protection will be closed aotumatically FIGURE 2 NO 3)
7.2.9 Afterr the end of cutting action, remove the hand pressure on the button. Both of the saws will come to the initial
position.
7.2.10 After the end of cutting action, remove the hand pressure on the button
7.2.11 Use the motor stop button to stop the saw rotation.
NOTE: Remove the pressure on the cutting buttons in a possible hazard, or press the emergency stop
button.
Motor Start-
Stop Button
Degree Selection
Button
Double Hands
Cutting Button
Emergency Stop Button
FIGURE-13
Clamp Button
(When pressing the double hands buttons, the top
Degree Selection
Button
Double Hands
Cutting Button
45