Operation; Preparation - YILMAZ ACK 420 Manual

7. OPERATION

7.1 Preparation

7.1.1 Degrease and dry the machine table. Especially ensure that the holding grips and handles are clean and dry
7.1.2 Clean all surfaces of the machine from chip and foreign particles. Use eye glasses for protection.
7.1.3 Our portable end milling machine KM 213-215 is used for working of non-ferrous materials, aluminum and PVC
mullion profiles to make <T > connections.
7.1.4 Control whether cutting tools (FIGURE 10 NO: 47) are inserted safely to their places.
7.1.5 Control cutting tools against corrosion, distortion and fractions. If cutting tools are damaged, change them.
7.1.6 Cutting tool must process on the part after machine is operated and cycled.
7.1.7 Do not process the profile before clamping the work piece properly.
7.1.8 Adjust the reducer speed adjustment screw (FIGURE 11 NO 107) by rotating in the direction of clockwise until
providing the desired progress if the saw group cutting progress is fast. Make the opposite of the above action if
the saw group cutting progress is slow.
37