Operation - YILMAZ ACK 420 User Manual

7. OPERATION

7.1 Preparation
7.1.1 Degrease and dry the machine table. Especially ensure that the holding grips and handles are clean and dry.
7.1.2 Clean all surfaces of the machine from chip and foreign particles. Use eye glasses for protection.
7.1.3 This machine can process on products manufactured from rigid plastic and aluminum materials that don't
include iron alloy.
7.1.4 Control whether cutting tool ( FIGURE – 3 NO.73 ) is inserted safely to their places.
7.1.5 Control cutting tools against corrosion, distortion and fractions. If cutting tools are damaged, change them.
7.1.6 Cutting tool must process on the part after machine is operated and cycled.
7.1.7 Absolutely control the direction of rotattion of the saw.
7.1.8 Do not process the profile before clamping the work piece properly !...
7.1.9 Adjust the reducer speed adjustment screw ( FIGURE – 2 NO.10 ) by rotating in the direction of clockwise until
providing the desired progress if the saw group cutting progress is fast. Make the opposite of the above action if
the saw group cutting progress is slow.
46