Operation; Preparation - YILMAZ CK 412 User Manual

7. OPERATION

7.1 Preparation

7.1.1 Clean the glazing bead mould channels from any burr and foreign materials. Ensure especially that the glazing
bead moulds are clean.
7.1.2 Clean all surfaces of the machine from chip and foreign particles. Use eye glasses for protection.
7.1.3 The CK 412 Automatic Glazing Bead Saw has been designed for cutting of aluminum and PVC glazing beads at
7.1.4 Control whether cutting tools are inserted safely to their places.
7.1.5 Control cutting tools against corrosion, distortion and fractions. If cutting tools are damaged, change them.
7.1.6 Cutting tool must process on the part after machine is operated and cycled.
7.1.7 Do not process the profile before clamping (PICTURE 4 NO.76/7) the work piece properly.
7.1.8 Up-Down adjustment of glazing bead mould can be performed by adjustment part on the machine. (PICTURE 4
NO.49) First loosen the set square fixing set screws (PICTURE 4 NO.5). Make the adjustment by turning the
knob up/down. Then again tighten the set screws and nut.
7.2 Operation
7.2.1
7.2.2 Place bar profile to be cut as shown in PICTURE 7.
.
(PICTURE 6 NO.34)
36