Table of Contents
Advertisement
Section 2: Setup and Preparation for Operation
Connecting Power
NOTE: Use a surge protector to isolate the instrument from electrical spikes and surges.
1. Make sure the power switch is OFF (O).
2. Plug the power cord into the power connector on the rear panel of the instrument.
3. Plug the power cord into a properly rated AC electrical outlet.
4. Turn the power switch ON (I). After a brief delay the Main menu will appear.
NOTE: Ensure the waste tube has no loops or kinks and is as straight and as
short as possible. Cut off excess tubing as needed.
3. Connect the drain tube to the waste container.
4. If using a waste bottle with level detect (AC-182):
Connect the waste monitoring cable to the rear panel receptacle.
5. Connect the waste monitoring cable to the waste container lid.
23
23
Advertisement
Table of Contents
