Set / Unset System; Forced Arm On Inputs - Pyronix Castle EURO 46 Series Programming Reference Manual

3.7 Set / Unset System

Setting and unsetting the system can be done using the Engineer code (default 1111).
NOTE: The term 'areas' will refer to both areas and level sets in this manual, also note that the
number of areas and level sets will differ depending on the EURO control panel installed. To change
the EURO control panel into a level set system, please refer to 'SITE OPTIONS' (page: 26).
1. Enter the Engineer code (default 1111).
2. Press if any faults appear.
3. 'SET/UNSET SYSTEM' is displayed.
4. Press .
5. Select the areas to set. Press .
6. The setting period will begin.
7. Once the timer expires, and a beep is heard, control panel
is set.
8. To unset, enter the Engineer code again.
NOTE: If a wireless ZEM (EURO-ZEM32-WE) is installed, the
display will show 'Please Wait Setting Wireless' and then will
revert to the 'Setting' to display.

3.8 Forced Arm On Inputs

The 'Force Arm On Inputs' function enables two nominated inputs on the EURO control panel to be
set. Either input can be triggered to allow real life signalling or alarm testing. This function is useful
when a building is full of people and these tests are needed.
NOTE 1: The system will give the correct signalling response to the Setting, and any resulting alarm.
NOTE 2: If the system has been set by any other code, the Engineer code will unset the EURO
control panel.
9. Enter the Engineer code (default 1111).
10. Press if any faults appear.
11. 'SET/UNSET SYSTEM' is displayed.
12. Press .
13. 'FORCE ARM ON 1st INPUT' is displayed.
14. Enter the 1st input that is to be active. Press .
15. Enter the 2nd input that is to be active. Press .
16. Select the areas to set. Press .
17. The setting period will begin
18. Once the timer expires, and a beep is heard, the
EURO control panel is set and the 2 inputs chosen will
be active.
19. To unset, enter the Engineer code again.
EURO 46, 162 & 280 Programming Manual
Page: 9
SET / UNSET
SYSTEM?
Setting [007]
Full Set
FORCE ARM ON 1st
INPUT? [01]
FORCE ARM ON 2nd
INPUT? [01]