Text Programming; Grade 2 And Grade 3 Defaults - Pyronix Castle EURO 46 Series Programming Reference Manual

3.4.2 The Internal Tag Reader (EUR-107)
The Internal tag reader can be used for setting/unsetting, entry control or access control. Refer
to the installation manual (RINS1529) for connection details.
3.4.3 The External Tag Reader (EUR-108)
The Internal tag reader can be used for setting/unsetting, entry control or access control. Refer
to the installation manual (RINS1529) for connection details.

3.5 Text Programming

Text may be programmed for input names, for the 'sign-on'
message, and to identify the Set Level being set / unset. Each key is
allocated alpha-numeric and punctuation mark characters.
The EURO control panel incorporates predictive text, so the system
will predict the word that is being spelt. For example, if 'B' is
pressed, and then  and 'e' is pressed, Bedroom will be displayed,
to accept this press . If the word that is required doesn't appear
on the LCD display, type the word as normal.
To type a word, press the relevant key the appropriate number of
times – e.g. for the letter 'k' press  twice, or for the letter 's'
press  four times. For punctuation marks, press the  key.
In addition, the keys are used as follows:
 = make the character into a capital  = move cursor left = clears cursor / adds a space
 = moves cursor right

3.6 Grade 2 and Grade 3 Defaults

The security grade of the EURO control panel can either Grade 2 or Grade 3
In the 'CLEAN START' function (Page: 38), enter '2002' for Grade 2 defaults, or '2000' for Grade 3
defaults.
*
The EURO 46 Small control panel will only conform to Grade 2
EURO 46, 162 & 280 Programming Manual
To set/unset the system using the External Tag Reader,
present a pre-programmed tag to the centre of the prox.
The prox will display the system status: Green = Unset.
Red = Set. Present the tag again within 10 seconds and
the system will set or unset.
The system will then set depending on the type of exit
mode programmed (Final door, Timed or Push to set)
Page: 8
Tag Area (Where a valid tag must
be presented to set/unset)
Alert LED
Alarm LED
Tamper LED
Fault LED
Unset LED
*.
*