Front Panel - ADTEK CM1 Series User Manual

■
OPERATING
■

FRONT PANEL

Relay status
R L 1
indication
RL2
Display
screen

:
Number screen
●
:
r ed high-brightness LED

Output LED:
●
Relay Energized: 2 square red LED
display when Relay 1 energized
RL2
display when Relay 2 energized;
RS485 Communication
flash when the meter is receive or send data, and
quickly means the data transient quicker.

:
Stickers Each instrument will be attached to the
relay function are engineering
units stickers and stickers; Please choose according
to site usage label affixed to the front panel functions
。
and units
OPERATING KEY
■
*Please access to the Programming Level to check and set the parameters when users start to run the meter

Operating Key: 4 keys for

The meter has designed operation similar as PC's
press key means "escape(

In Programming Level, the screen will return to Measuring Page after do not press any key over 2 minutes, or press
(1) In any page, press
(= )
(2) From the function index to access setting status
Enter/Fun key
(= ) (1) In measuring page, press
(2) In function index, press
Shift key
(3) In function group index, press
measuring page
(= )
(1) In function index, press
Up key
(= )
(1) In Function Index Page, press
Index Page.
Down key
4 / 28
Communication
COM
status indication
Engineer Unit
~A
.
；
: ;
1 square orange LED
。
:
Enter(Function) / Shift(Escape) /
)" or "shift".
Esc
Function Index
to access the level or function index
for 1 second to access user level.
for 1 second to go back upper level.
for 1 second to go back
to go back to previous function index (2) In setting status for function, press
will go to the next Function
●
:
Stickers
H i
Hi Action
●
Hi Action &Hold
●
Unit stickers:

Operating Key: 4 keys for
Shift(Escape) /

Pass Code:
will
4-digit password to set; To enter the parameter screen,
flash
you must enter the correct
password, please remember the password. If youforget
the password, please contact the company. This
password can be in steps [Pcode] to change
Up key / Down key
and . In any page, press
(3) Setting Confirmed, save to EEProm and go to next
function index
(4) In setting status, press
(5) In setting status, press
and go back this function index.
(3) During number Setting, press
(2) In setting status for function, press
function
(3) During number Setting, press
down.
CM1-SERIES
L o
Lo Action
Lo Action &Hold
106 kinds
Enter(Function) /
Up key / Down key
key means "enter" or "confirm setting", and
Setting Status
to Shift the setting position.
for 1 second to abort setting
can roll the digit up
can roll the digit
for 1 second.
to select function
to select
Rev 1.3
2018-07-02