Connecting The Unit To The Power Supply And Existing Network - Dentsply Sirona CEREC SpeedFire Operating Instructions Manual

Dentsply Sirona
Operating Instructions CEREC SpeedFire
65 71 165 D3639
D3639.201.01.08.02 01.2020
4.5.3 Connecting the unit to the power supply and existing
network
Connecting the unit to the power supply
Only use the power cord supplied in the package for connecting to the
mains. The unit must be connected directly to a fixed socket and must
not be bridged via an extension cable.
➢ Connect the unit to the power supply.
Connecting the control panel
➢ Connect the control panel directly to the primary unit using the
communication cable. Make sure that both knurled screws on the
connector are fastened tightly.
Connecting the unit to the network
➢ Integrate your unit into your existing network via the LAN "Ethernet"
connection. Use the network cable supplied for this and the LAN
switch delivered as an option if applicable.
Fasten the ferrite core
1. Place the network cable into the open ferrite core.
2. Close the ferrite core until it locks into place.
4 Transport and commissioning
4.5 Setup/connection
33