Transport And Commissioning; Unpacking; Repacking; Disposal Of Packaging Materials - Dentsply Sirona CEREC SpeedFire Operating Instructions Manual

4 Transport and commissioning

4.1 unpacking

30
4
Transport and commissioning
unpacking
4.1
All products from Dentsply Sirona are carefully checked prior to
shipment. Please perform an incoming inspection immediately after
delivery.
1. Check the delivery note to ensure that the consignment is complete.
2. Check whether the product shows any visible signs of damage.
NOTE
Damage during transport
If the product was damaged during transport, please contact your
carrying agent.
If return shipment is required, please use the original packaging for
shipment.
If you no longer have the original packaging, this can also be reordered.
The order number is 65 82 899.
Before shipping the unit, remove the door insulation (top/bottom) and
the positioning pin and close the furnace door.

Repacking

4.2
ü The main switch on the back side of the unit is set to the 0 (OFF)
position.
1. Pull out the power cable.
2. Loosen both knurled screws on the communication cable connector
and pull it out.
3. Stow the power cable and the communication cable.
4. Check the unit for completeness according to the scope of delivery.
5. Pack the unit securely.

Disposal of packaging materials

4.3
The packaging must be disposed of in compliance with the relevant
national regulations. Please observe the regulations applicable in your
country.
Dentsply Sirona
Operating Instructions CEREC SpeedFire
65 71 165 D3639
D3639.201.01.08.02 01.2020