Table of Contents
Advertisement
Chapter 5 – Programming
Output Selections
15.1 Analogue Output 1
15.6 Analogue Output 2
Data sets
5-8
The ACS 600 drive has two user-configurable ' data sets' . These output reg-
isters are intended for transferring fast, real time data out from the drive to the
controlling device.
The selection of signals is done through the analogue output selectors.
Defines the signal on data set 5.
NOT USED, P SPEED, SPEED, ... , ACTUAL 2
Analogue signal selections as in the ACS 600 Programming Manual.
Defines the signal on data set 6.
Selection is the same as for Parameter 15.1 Analogue Output 1.
Data sets on the ACS 600 drive are very fast communication data transfer
areas. These are excellent for fast control, and for reading back critical actual
values.
The data sets are fixed in the drive application software, and cannot be modi-
fied by the end customer. The standard software has six data sets, numbered 1
through 6.
Installation and Start-up Guide for NMBP-01
Advertisement
Table of Contents
