ABB NMBP-01 Installation And Startup Manual page 45

Installation and Start-up Guide for NMBP-01
The ss subfield in error code 30ss is:
ss Hex Value Meaning
01 Slave device does not support the requested operation
02 Nonexistent slave device registers requested
03 Invalid data value requested
04
05 Slave has accepted long-duration program command
Function cannot be performed now – long-duration command in
06
effect
07 Slave rejected long-duration program command
08 ... 255
The m subfield in error code 6mss is an index into the routing information
indicating where an error has been detected – a value of 0 indicates the local
node, a 2 the second device on the route, etc. The ss subfield in error code
6mss is:
ss Hex Value
01 No response received
02 Program access denied
03 Node off-line and unable to communicate
04 Exception response received
05 Router node data paths busy
06 Slave device down
07 Bad destination address
08 Invalid node type in routing path
10 Slave has rejected the command
20 Initiated transaction forgotten by slave device
40 Unexpected master output path received
80 Unexpected response received
F001 Wrong destination node specified for the MSTR operation
Chapter 7 – Fault Tracing
Meaning
7-5