ADIC Scalar 1000 User Manual page 97

Example:
foster > ethAddrSet "10.0.0.2", "255.0.0.0"
Example:
foster > gateAddrSet "192.168.1.1"
value = 0 = 0x0
Example:
foster > route "add", "206.0.0", "192.168.1.1"
value = 0 = 0x0
Step 4.
Example:
foster > userAdd "username","password"
value = 0 = 0x0
foster >
Step 5.
Example:
foster > reboot
6-00020-02
SNC 5100
If you need to set a netmask, specify it after the network address:
If you need a network route and/or default gateway, you must
specify it.
When more complicated routing is required, use the route
command to specify the destination address, as a full address
(single host) or as an abbreviated subnet address.
Specify the address of the gateway that is reachable on the local
subnet.
Optionally, add User account for Telnet
If you want to access the SNC 5100's command line interface
through its Ethernet port using a Telnet session, you need to add a
user account.
The user name you specify must be 3 or more characters. The
password you specify must be 8 or more characters.
For more information, see the commands beginning with
the "Service Port Command Reference" on page 105.
Enter the command to reboot the SNC 5100:
reboot
For more information, see the
"ethAddrSet" command on page 121
Network Setup for the SNC 5100
in
user
.
89