ADIC Scalar 1000 User Manual page 80

lo (unit number 0):
Flags: (0x8069) UP LOOPBACK MULTICAST ARP RUNNING
Type: SOFTWARE_LOOPBACK
Internet address: 127.0.0.1
Netmask 0xff000000 Subnetmask 0xff000000
Metric is 0
Maximum Transfer Unit size is 32768
0 packets received; 0 packets sent
0 multicast packets received
0 multicast packets sent
0 input errors; 0 output errors
0 collisions; 0 dropped
value = 29 = 0x1d
Step 15.
Step 16.
Step 17.
Step 18.
Step 19.
72 Ethernet MAP
If there is no entry for
Go to "Before Removing or Replacing the Unit" on page 82.
Continue through "Replacing the SNC 5100" on page 84.
Exit this MAP.
If there is an entry for
- internet address,
- netmask,
- subnetmask
Verify that the internet address is the same as the IP address
supplied by the network administrator.
Verify that the netmask value is the same as the netmask in hex
format supplied by the network administrator.
Verify that the subnetmask is the same as the netmask. If these
values are correct, go to step 21.
If these values are not correct, proceed to Step 19.
Use the
ethAddrSet
netmask values.
For more information, see the
121.
SNC 5100
, replace the SNC 5100.
ibmEmac
, write down the values of the:
ibmEmac
command to set the correct IP address and
"ethAddrSet"
command on page
6-00020-02