Test Gbic - ADIC Scalar 1000 User Manual

Step 2.
Step 3.
Step 4.
Step 5.
Step 6.

Test GBIC

Step 1.
Step 2.
62 Fibre Channel MAP
SNC 5100
Press the Enter key on the service terminal.
If the prompt is not displayed, go to "Service Port MAP" on
page 75.
From the service terminal, enter the
For more information, see the
Confirm that the Fibre Channel connections are correctly displayed.
If displays the Fibre Channel connections correctly, go to
showBox
"Examine Cables".
If the Fibre Channel connections do not display correctly in the
display, remove the GBIC and replace it with a
showBox
known-good GBIC.
Go to "Removing the GBIC" on page 82.
Proceed through "Replacing the GBIC" on page 82.
Proceed to "Test GBIC".
Caution
You must stop I/O at the Fibre Channel host.
With a known-good GBIC installed, confirm that the SNC 5100's
Fibre Channel connections are correctly displayed by issuing the
command from the service terminal.
showBox
For more information, see the
If the output of the
showBox
configuration, exit this MAP.
If the output of the
showBox
Fibre Channel configuration, remove the known-good GBIC and
reinstall the original GBIC.
Go to "Examine Cables".
command.
showBox
command on page 170.
"showBox"
command on page 170.
"showBox"
command matches the Fibre Channel
command, still does not match the
6-00020-02