Boot Mode Commands; Diagnostic Commands - ADIC Scalar 1000 User Manual

Boot Mode Commands

diagBoot
This command is used only to transition an SNC 5100 from normal operations
to the special diagnostic mode.
• The
exists.
• It copies the existing bootline to a file in the
SNC 5100.
• It installs a new bootline directing the SNC 5100 to boot using a special
diagnostic startup
• It renames the persistent map file
config/device.bak
• It issues a
normalBoot
The normalBoot command is used only to transition the SNC 5100 from the
special diagnostic mode to resume normal operation.
• It restores the bootline that was copied by
• It erases the new persistent device map and renames the original map file
config/device.map
• It reboots the SNC 5100.

Diagnostic Commands

This section is a reference for the commands that are available when the SNC
5100 is booted in diagmode.
The command set is limited while in
showBox
the Ethernet, Fibre Channel, and SCSI interfaces.
6-00020-02
Caution
All SCSI and FC cables must be disconnected before entering the
command.
diagBoot
command first ensures that the
diagBoot
script /ffs:mt/diagnstk.rc.
(a new file will be generated after rebooting).
command to put the changes into effect.
reboot
– restoring it for use when the SNC 5100 reboots.
command and three commands (with the suffix
SNC 5100
/nvfs:mt
config/device.map
diagBoot
. You will need to use the
diagmode
directory
/nvfs:mt
directory on the
as
.
) when testing
Test
Boot Mode Commands 191