Service Port Map - ADIC Scalar 1000 User Manual

Example:
SN60023 > gateAddrGet
Gateway Address set to 192.168.1.1
value = 0 = 0x0
Step 33.
Step 34.
Step 35.
Step 36.

Service Port MAP

These steps are performed if the SNC 5100 boots and responds to the ADIC
Management Console, but the Service Port does not respond.
For more information, see the ADIC Management Console User Guide.
6-00020-02
SNC 5100
If both addresses are the same, go to step 33.
If the network gateway address is incorrect, set it to the value
provided by the network administrator using the
command.
For more information, see the
131.
From the service terminal, enter the
Wait until the SNC 5100 has finished booting.
From the service terminal, use the
address of the ADIC Management Console Server.
For more information, see the ADIC Management Console User
Guide.
From the host running the ADIC Management Console Server,
PING the SNC 5100.
If both PING tests succeed, exit this MAP.
If a PING test fails, inform the network administrator to check and
correct the network connection, route tables, and network gateway
addresses for both the ADIC Management Console Server and the
SNC 5100.
gateAddrSet
command on page
"gateAddrSet"
command.
reboot
command to PING the IP
ping
Service Port MAP 75