Saving A Configuration File; Loading A Configuration File - ADIC Scalar 1000 User Manual

Saving a Configuration File

Step 1.
Step 2.
Step 3.
Step 4.
Step 5.

Loading a Configuration File

Step 1.
Step 2.
6-00020-02
SNC 5100
If HyperTerminal reports an error, try to send the file again.
If the SNC 5100 reports an error, make a note of the error code and
see the Table 12, "Zmodem Status Codes," on page 100 for further
information.
From the HyperTerminal window enter
.
<Enter>
The filename
" config.cfg "
specify a different filename but it must be in quotes, it must be 8
characters or less and it must end in .cfg.
From the HyperTerminal window select
.
File
From the
Receive File
you want to save the file or click the
it.
For the Receiving protocol select
button.
Wait for the "Configuration Download Complete" status message to
be displayed on the service terminal indicating successful
completion.
If HyperTerminal reports an error, try to receive the file again.
If the SNC 5100 reports an error, make a note of the error code and
see the Table 12, "Zmodem Status Codes," on page 100 for further
information.
From the Hyper Terminal window, at the
prompt, type and then press the
rz
From the HyperTerminal window select
.
File
sz " config.cfg "
is an example of a name. You can
Transfer
dialog enter the path to the folder where
button and navigate to
Browse
and press the
Zmodem
SN60023 >
key.
Enter
Transfer
Updating Firmware and Configurations
and
Receive
Receive
command
and
Send
99