Initial Post; Simple Access Test - ADIC Scalar 1000 User Manual

SNC 5100

Initial POST

Figure 11 Initial POST
starts by initializing the service-port and the system PLD(s). The
IpostMain
ERR LED will extinguish and the RDY LED will turn on. POST will display
the following message on the service port:
== POST Version nnn ==

Simple Access Test

Figure 12 Simple Access
The simple access test verifies that the processor can perform basic writes and
reads to the SDRAM. This test is identified by the flash of the FC1 LED.
198 POST Boot Behavior
6-00020-02