Updating Firmware And Configurations; Updating Snc 5100 Firmware - ADIC Scalar 1000 User Manual

Updating Firmware and Configurations

Although the ADIC Management Console is the simplest and most efficient
tool for updating firmware and saving/loading configurations, you can use the
service terminal as an alternate method to perform these operations.
For more information, see the ADIC Management Console User Guide.
The ADIC Management Console service port supports Zmodem file transfers.
The procedures below are specific for using the HyperTerminal program on the
service terminal to transfer files. Other terminal emulation programs operate in
a similar fashion.
The Zmodem send and receive functions in some terminal emulation programs
automatically issue the command string "
command string "
are using automatically sends the "
command string "
transfer.

Updating SNC 5100 Firmware

Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Step 7.
98 Updating Firmware and Configurations
SNC 5100
" before receiving a file. However, even if the program you
sz
" before starting the transfer has no negative effect on the
rz
From the Hyper Terminal window, at the
prompt, type and then press the Enter key.
rz
From the HyperTerminal window select
.
File
From the
Send File
firmware file is located or click the
it.
In the field, select
Protocol
It will take several minutes for the file to be transferred. The
Zmodem file send dialog will display the current status and it will
close automatically when the file transfer has completed.
Wait for the Firmware Update Complete status message to be
displayed on the service terminal indicating successful completion.
Reboot the SNC 5100 for the update to take effect.
For more information, see the
" before sending a file and the
rz
" command, manually issuing the
rz
SN60023 >
Transfer
dialog enter the path and filename where the
Browse
and click the
Zmodem
command on page 151.
"reboot"
command
and
Send
button and navigate to
button.
Send
6-00020-02