Device Access Map - ADIC Scalar 1000 User Manual

Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Step 7.

Device Access MAP

Perform these steps if a host is not able to access SCSI or Fibre Channel
devices.
Step 1.
48 Device Access MAP
SNC 5100
that are not currently attached will be removed from the database.
You must reboot the SNC 5100 after performing this procedure for
the changes to take effect.
Connect a service terminal to the SNC 5100.
For information about how to do this, see "Connecting to the
Service Port" on page 95.
Press the Enter key on the service terminal.
If the prompt is not displayed, go to "Service Port MAP" on
page 75.
From the service terminal, enter the
to display the contents of the database.
For more information, see "mapShowDatabase" on page 146.
From the service terminal, enter the
display LUN assignments for the attached devices that have been
mapped.
For more information, see the
147.
From the service terminal, enter the
command to remove LUN assignments for devices that no longer
need to be kept.
For more information, see the
on page 148.
Reboot the SNC 5100.
After the SNC 5100 has finished booting, repeat steps 3 and 4 to
verify that all attached devices have been mapped.
Connect a service terminal to the SNC 5100.
mapShowDatabase
mapShowDevs
command on page
"mapShowDevs"
mapWinnowDatabase
"mapWinnowDatabase"
command
command to
command
6-00020-02