Select 2- Or 3-Point Calibration (Only For Ph Measurement); Select Temperature Unit (°C/°F); Set Temperature Offset - JUMO 202710 Operating Instructions Manual

3.2 Select 2- or 3-point calibration
3.3 Select temperature unit (°C/°F)
3.4

Set temperature offset

Start configuration.
Select the parameter "CAL".
min
Use the or
max
5
2
rH mV mV pH
H
max
2
mbar
min
5
ATC ok CAL AL Logg pH
2-Pt: 2-point calibration.
The calibration of the pH combination electrode is carried out for two
points (one point in the neutral range, and one point in the acidic or
alkaline range).
3-Pt: 3-point calibration.
The calibration of the pH combination electrode is carried out for three
points (one point in the neutral range, and one point each in the acidic
and alkaline ranges).
Start configuration.
Select the parameter "Unit".
min
Use the or
max
2 5
rH mV mV pH
H
max
2
mbar
min
5
ATC ok CAL AL Logg pH
°C All temperature values in degrees Celsius.
°F All temperature values in degrees Fahrenheit.
Start configuration.
Select the parameter "OFFS".
(only for pH measurement)
key to select the type of calibration.
key to select the temperature unit.
3 Configuration
11