2 General
2.4
Controls
8
(10)
(11) (12)
ON
OFF
max
1
2
Set
min
Menu
4
5
(13)
(10) On/off switch
(11) min / max or "up" / "down"
During measurement:
- press briefly:
- press for 2 seconds:
In the Set / Menu level:
(12) CAL (only on the "pH" mode)
- press briefly:
- press for 2 seconds:
(13) Set / Menu
- press briefly (Set):
- press for 2 seconds:
(Menu):
(14) Store / Quit:
During measurement:
For Set / Menu:
CAL
3
Store
Quit
6
(14)
displays the minimum or maximum
value measured up to now.
deletes the corresponding value.
entry of values or changes to settings.
displays the electrode condition and
calibration data.
starts the pH calibration.
for "pH", "rH" and "mV
manual temperature entry, if no
temperature probe is connected.
Additionally, for "rH":
manual entry of the pH value.
set the operating mode.
call up the configuration.
hold and store the present measurement.
The display shows HLD.
confirms the entry,
returns to measurement.
":
H