Installation Of The Sensor; Removal Of The Sensor - Xylem MJK SuSix Installation And User Manual

Turbidity and Suspended Solids Transmitter
2. Apply Loctite 577 around the male threads (skipping the leader),
tighten the A and B nuts, and allow the sealant to cure for about 72
hours (3 days) to achieve full strenght.
3. Weld the Insertion Fitting to the tube (see also pages 17 - 19).

Installation of the Sensor

1. Set the sensor guide handle (7) in "Service" position.
2. Open the air relief valve on the underside (1) with a 5 mm hex key.
3. Carefully insert the sensor into the insertion fitting's built-in gasket
(inside 6) and lead the other end into the sensor guide (2).
4. Close the air relief valve on the underside (1) with a 5 mm hex key.
5. Make sure that the residual, in-line pressure is max. 1 bar !
6. Support the sensor end piece (3) and slowly open the ball valve (4).
Note: Rebounds may occur at this point !
7. Release (pull out) the safety lock (5), and at the same time pull the sen-
sor guide handle (7).
8. When the end piece (3) touches the insertion fitting body (6), the sen-
sor guide handle (7) has reached its "Measure" position, and the safety
lock (5) engages (falls into place) with audible click.
9. Make sure that the safety lock (5) has been engaged (in locked posi-
tion).

Removal of the Sensor

1. Make sure that the residual, in-line pressure is max. 1 bar !
2. Release (pull out) the safety lock (5), and at the same time push the
sensor guide handle (7) forwards to extract the sensor from the inser-
tion fitting body (6).
Note: Rebounds may occur at this point !
3. The sensor guide handle (7) is in "Service" position, when the safety
lock (5) engages with a click.
4. Close the ball valve (4).
5. Open the air relief valve (1).
6. Support the sensor end piece (3), and carefully lift the sensor out of the
sensor guide (2).
7. Close the air relief valve (1).
8. Remove the sensor.
EN 5.10 SuSix Manual 2007 22 FW: 841013-005/843003-001