Xylem MJK SuSix Installation And User Manual page 97

Turbidity and Suspended Solids Transmitter
Sensor
Sensor communication
Sensor hardware
Sensor setting
Sensor supply
Sensor wiper
System
System error
Turbidity offset
Needs higher meas.sample
Needs lower meas.sample
Sensor range exceeded
EN 5.10 SuSix Manual 2007
Error - General sensor error that
may also be transferred to a relay
output.
Contact MJK.
Error - Check the cable condition
and tighten the connectors.
Error - Change the sensor hard-
ware.
Error - Some settings are wrong or
have been changed.
Error - The sensor supply is too
low or too high. Check the sensor
cable connection.
Error - Make sure that the wiper is
free to move and not obstructed by
dirt deposits.
Error - Internal VCC error. See the
event log for details.
Error - The system software is in-
operable including faulty alarm and
sensor bits.
Contact MJK.
Error - A zero-point probe prob-
lem. The sensor needs a zero
calibration.
Contact MJK.
Warnings
Warning - Calibrate at a higher
concentration.
Warning - Calibrate at a lower
concentration.
Warning - The measured value is
out of range. Check the measuring
range and the measuring units.
97 FW: 841013-005/843003-001