Table of Contents
Advertisement
14 SOFTWARE UPGRADE
In the STANDARD version, the software can be upgraded using a special ecoLINK II interface
only. To upgrade the TOUCH version software, use micro SD memory card or the ecoLINK II
interface. In this section, software upgrade in the TOUCH version using memory card is
described.
Fig. 27 Inserting a microSD card
Menu → General Settings → Software Upgrade and upgrade the software: first in the A
module, then in regulator's control panel.
Note: software may be upgraded
by authorised personnel only. All
electric
measures must be applied!
To upgrade the software, disconnect power
supply
of
the
ecoTOUCH control panel from the regulator
housing. Insert memory card into indicated
slot.
Memory
card
software stored in the *.pfc format (two files:
one with software for control panel, and the
other one with software for module "A" of the
regulator). Upload new software directly to
the memory card. Do not nest data in sub-
directory. Re-install
regulator housing and connect power supply.
Enter:
shock
preventive
regulator
and
remove
should
contain
the control
panel in
new
36
Advertisement
Table of Contents
