Table of Contents
Advertisement
Fuse replacement 1 – fuse, 2 – fuse
Fig. 26
holder
To remove the fuse, press down fuse holder
using flat screwdriver and turn it in CCW
direction.
24.2
Replacement of control panel
In case of required replacement of control
panel only - make sure the software used in
new panel is compatible with the software of
working module. Compatibility is guaranteed
if first component of software ID number of
the panel and of the working module is the
same.
In following example, software is
compatible because first component of its ID
number
("01")
is
components.
Example of software ID number:
Control panel:
01.10.010.
Software ID number may be taken
from the rating plate of respective
component
Information
Incompatibility of control panel and
working
incorrect operation of the regulator.
24.3
Replacement of working module
The requirements are the same as for the
replacement of control panel - see sec.24.2.
the
same
for
both
Working module:
01.11.026.R1
or
from
Menu
module
may
cause
24.4
Software up-grade
To up-grade the software - use micro SD
memory card or special interface ecoLINK II.
In this section, software up-grade using
memory card is described. To up-grade the
software - disconnect power supply to the
regulator and remove ecoTOUCH control
panel from the regulator housing acc. sec.
13.1. Insert memory card into indicated slot.
Memory card should contain new software in
*.pfc format (two files - one with software
for control panel, and the other one with
software for module "A" of the regulator).
Upload new software directly to memory
card. Do not nest data in sub-directory. Re-
install the control panel in regulator housing
and connect power supply. Enter:
General settings > Software Up-grade
and up-grade the software at first in module
A of the regulator, and next in the control
panel.
Fig. 27 Placing of microSD memory card
43
Advertisement
Table of Contents
