Yamaha OWNER'S MANUAL HTR-6130 Owner's Manual page 63

• Remote control
The remote control Wrong distance or angle. The remote control functions within a maximum 21
does not work nor range of 6 in (20 It) and no more than 30 degrees
function properly, off-axis from the front panel.
Direct sunlight or lighting (from an Reposition this unit.
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak. Replace all batteries. 3
The remote control code is not correctly Set the remote control code correctly using "List of 53
set. remote control codes" at the end of this manual.
Try setting another code for the same manufacturer
using "List of remote control codes" at the end of this
manual.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
53
• Resetting the system
Use this feature to reset all the parameters of this unit to
the initial factory settings.
1
Press @STANDBY/ON on the front panel to
set this unit to the standby mode.
Press and hold @TONE CONTROL and
then press @STANDBY/ON to turn on this
unit.
The advanced setup menu appears in the front panel
display.
Press @PROGRAM <1/t> to select
"PRESET".
Press @STRAIGHT repeatedly to select
"RESET".
Select "CANCEL" to cancel the initialization
procedure without making any changes.
Press @STANDBY/ON to confirm your
selection and set this unit to the standby
mode.
• This procedure completely resets all the parameters of this unit
including the set menu parameters.
• The initial factory settings are activated next time you turn on
this unit.
To cancel the initialization procedure at any time without making
any changes, press @STRAIGHT repeatedly to select
"CANCEL" and then press @STANDBY/ON
59
En