Yamaha OWNER'S MANUAL HTR-6130 Owner's Manual page 23

Both FM and AM indoor antennas are supplied with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
• The AM loop antenna should be placed away from this unit.
• A properly installed outdoor antenna provides clearer reception
than all indoor one. If you experience poor reception quality,
install all outdoor antenna. Consult the nearest authorized
Yamaha dealer or service center about outdoor antennas.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
Outdoor AM antenna _ AM loop
Use a 5 to l0 m (16 to 32
[_
antenna
ft) ol vilul-covered wire
(supplied)
extended outdoors h'om a
\Villd(}w.
I ndoor FM
antenna
(supplied)
lqllll:i"lffqli _
Assembling the supplied AM loop antenna
/
The types of the supplied AM loop antenna is different
depending on the models.
Once all connections are complete, plug the power cable
into the AC wall outlet.
Power cable
(U.S.A. model)
Ground
For maxinmm safety and minimum
interllzrence, connect the antenna GND
terminal to a good earth ground. A good earth
ground is a metal stake driven into moist earth.
To the AC wall outlet
• Turning on this unit
Connecting the wire of the AM loop antenna
Open the Insert Close the
lever lever
The wire of the AM loop antenna does not have any polarity
and you can connect either end of the wire to AM or GND
terminal.
Press @STANDBY/ON (or @ POWER) to turn
on this unit.
?_t_
When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
• Set this unit to the standby mode
Press @STANDBY/ON (or @ STANDBY) to set
this unit to the standby mode.
In the standby mode, this unit consumes a small amount of power
in order to receive infrared signals from the remote control.
19
En