Yamaha OWNER'S MANUAL HTR-6130 Owner's Manual page 12

_1 You must connect a cable TV or a satellite tuner to this unit ill
advance. See page 16 for details.
_2 You need to connect the supplied FM and AM antennas to this
unit ill advance. See page 19 for details.
_3 You have to tune into the desired radio station. See pages 37 to
39 for the tuning information.
_4 To achieve the best possible reception, orient the connected
AM loop antenna, or adjust the position of the end of the
indoor FM antenna.
ff you cannot find the desired situation, you can select and change
the assigned SCENE template for the SCENE buttons. See
page 24 for details.
• After using this unit...
Press @STANDBY/ON on the front panel to set
this unit to the standby mode.
This unit is set to the standby mode. To turn on this unit
from the standby mode, press @STANDBY/ON (or
@POWER) on the front panel. See page 19 for details.
In the standby mode, this unit consumes a small amount of power
in order to receive infrared signals from the remote control.
• Customizing the SCENE templates
• Using various SCENE templates
_ P. 24
• Using various input sources
• Basic controls of this unit _ P. 29
• Enjoying FM/AM radio programs _ P. 37
• Using your iPod with this unit _ P. 40
• Using the Bluetooth component _ P. 41
• Using various sound features
• Using various sound field programs
_ P. 34
• Adjusting the parameters of this unit
• Optimizing the speaker parameters for your
listening room (BASIC SETUP) _ P. 22
Manually adjusting various parameters of
this unit _ P. 43
Setting the remote control
_ P. 51
Adjusting the advanced parameters
_ P. 54
• Additional features
• Automatically turning off this unit
_ P. 33
SEn