Yamaha OWNER'S MANUAL HTR-6130 Owner's Manual page 60

iE'_m_'TE'T_IIEro
Only the center When playing a monaural source with a _._
speaker outputs CINEMA DSP program, the source signal _..._
substantial sound, is directed to the center channel, and the __
front and surround speakers output effect
sounds, x_
No sound is heard "CENTER" in "SPEAKER SET" is set to Set "CENTER" to "SML" or "LRG". 45
from the center "NONE".
speaker.
Some sound field programs do not output Try another sound field program. 34
sounds from the center speaker.
No sound is heard "sun. LR" in "SPEAKER SET" is set to Set "SUR. LR" to "SML" or "LRG". 45
from the surround "NONE".
speakers.
This unit is in the "STRAIGHT' mode Press @STRAIGHT on the front panel so that 36
and a monaural source is being played "STRAIGHT" disappears from the front panel
back. display.
No sound is heard "BASS OUT" in "SPEAKER SET" is set Set "BASS OUT" to "SWFR" or "BOTH". 46
from the subwoofer, to "FRNT" when a Dolby Digital or DTS
signal is being played.
"BASS OUT" in "SPEAKER SET" is set Set "BASS OUT" to "BOTH". 46
to "SWFR" or "FRNT" when a 2-channel
source is being played.
The source does not contain
low-frequency bass signals.
Dolby Digital or DTS The connected component is not set to Make an appropriate setting follo'Mng the operating --
sources cannot be output Dolby Digital or DTS digital instructions I_r your component.
played. (Dolby Digital signals.
or DTS indicator in
the front panel Audio input jack select is set to Set Audio input jack select to "AUTO". 31
display does not light "ANALOG".
up.)
A humming sound is Incorrect cable connections. Connect the audio cables firmly. It" the problem --
heard,
persists, the cables may be detective.
The volume level You are attempting to set the volume level Adjust "MAX VOL." setting. 48
cannot be increased, higher than the maximum volume level.
or the sound is
distorted. The component connected to the AUDIO Turn on the power of the component. --
OUT (REC)jacks on this unit is turned
off.
The sound effect It is not possible to record the sound effect
cannot be recorded, with a recording component.
A source cannot be
The source component is not connected to Connect the source component to the analog AUDIO 15, 17
recorded by an the analog AUDIO IN jacks on this unit. IN jacks.
analog component
connected to the
AUDIO OUT (REC)
jacks.
The sound field
parameters and some
other settings of this
unit cannot be
changed.
This unit does not
operate properly.
"MEM.GUARD" in "OPTION MENU" is Set "MEM.GUARD" to "OFF".
set to "ON".
50
The internal microcomputer has been
frozen by an external electric shock (such
as lightning or excessive static electricity)
or by a power supply with low voltage.
Disconnect the power cable from the AC wall outlet
and then plug it in again after about 30 seconds.
"CHECK SP WIRES" Speaker cables are short-circuited. Make sure all speaker cables are connected correctly. 11
appears in the front
panel display.
56
En