Yamaha OWNER'S MANUAL HTR-6130 Owner's Manual page 16

|¶'lllll_"l(|'lll-
• Connecting to the FRONT A terminals
2/
_" Red: positive(+)
Black: negative (-)
3
Caution
If you are to use 6 ohm speakers, set "SP IMP." to
"6f_MIN" as follows BEFORE using this unit.
1
Make sure this unit is turned off.
See page 19 for details about turning on or off this
unit.
2 Press and hold @TONE CONTROL and
then press @STANDBY/ON to turn on this
unit.
This unit turns on, an the advanced setup menu
appears in the front panel display.
1 Loosen the knob.
2 Insert the bare end of the speaker wire into
the slit on the terminal.
3 Tighten the knob to secure the wire.
Connecting the banana plug
(except Europe, Russia, Korea, and Asia models)
The banana plug is a single-pole electrical connector
widely used to terminate speaker cables. First, tighten the
knob and then insert the banana plug connector into the
end of the corresponding terminal.
Press @PROGRAM <1 It> repeatedly to
select "SP IMP.".
The following display appears in the front panel
display.
Banana plug
S P ]] ;"g P° - _i? ! ;;! H ]] N
4
Connecting to the FRONT B, CENTER,
and SURROUND terminals
Red: positive (+)
Black: negative (-)
1
Press down thetab.
2 Insert the bare end of the speaker wire into
the hole on the terminal.
3 Release the tab to secure the wire.
Press @STRAIGHT repeatedly to select
"6_MIN".
The following display appears in the front panel
display.
SP ]:MP°- 6_H]:N
5 Press @STANDBY/ON to confirm your
selection and set this unit to the standby
mode.
The setting you made is reflected next time you turn on this unit.
12
En