Yamaha OWNER'S MANUAL HTR-6130 Owner's Manual page 33

Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.
1
Turn on the video monitor connected to this
unit.
2 Press OSPEAKERS repeatedly to select the
front speakers you want to use.
The respective speaker indicators lights up in the
front panel display.
Press @INPUT <1/I> repeatedly (or press
one of the input selector buttons (@)) to
select the desired input source.
The name of the currently selected input source
appears in the front panel display for a few seconds.
Available input source
DVR V-AUX DTV,_BL I_DVD MD/BO-R TURER CD
• r b1Z:::' Zi"i" i_ r"_Z ir"_
Currently selected input source
Start playback on the selected component or
select a broadcast station.
• Refer to the operating instructions for the source
component.
• See page 37 for details about FM or AM tuning
instructions.
5
6
Rotate @VOLUME (or press @VOLUME
+/-) to adjust the volume to the desired
output level.
Press @PROGRAM <1/I> (or press @AMP
and then press @ PROG <1/c>) repeatedly to
select the desired sound field program.
The name of the selected sound field program appears
in the front panel display.
See page 34 for details about sound field programs.
,}
Currently selected surround field program
• Choose a sound field program based on your listening
preference, not merely on the name of the program.
• When you select an input source, this unit automatically selects
the last sound field program used with the corresponding input
source.
• Sound field programs cannot be selected when the component
connected to the MULTI CH INPUT jacks is selected as the
input source (see page 30).
• When PCM signals with a sampling frequency higher than 48
kHz are input, this unit is automatically set to the "STRAIGHT"
mode (see page 36).
• To display information about the currently selected input source
in the front panel display, see page 32 for details.
• Guideto contents
See
When you want to...
page
Adjust the tonal quality of the front speakers 31
Edit parameters of sound fiekt programs 35
Enioy the sources which have wide dynamic range at 31
night
Use headphones 30
Select a decoder to play back sources with 35
Set this unit to the standby mode automatically 33
29
En