Yamaha OWNER'S MANUAL HTR-6130 Owner's Manual page 48

_frr_fi'
Option menu 3 ()F'[ ]I()H MENU
Use this menu to manually adjust the optional system parameters.
1...1 )L ) .!. ' .:::,{'L.H"_" '.:::,1:::. ! Actiusts the brightness of the front panel display. 50
ii:.i', Z; _Mii:.ilM('.)i::'?.Y (:.iiLiAi::'?.iZ[) Locks sound field program parameters and other set menu settings. 50
i.: )!"!U!).!. U '.:';,!:';.L.!:';.L: ! Designates the default audio input jack select setting mode for the input sources connected 50
to the DIGITAL INPUT jacks when you turn on the power of this unit.
D Z; _{:::'{:::{{:;;'.{:::{{"{ = Zi=i {..{ ] Sets all the parameters of the sound field programs to the initial factory settings. 50
{i:.il Z;' { i:.i',L.U{i:.ii"['('.) ('.)T{"{ Pairs the connected Yamaha Bluetooth adapter (such as YBA-10, sold separately) with a 50
Bluetooth component (see page 41 ).
• Signal information :iii;:[(iiii..i{:::{L :[i..iF:O
Use this feature to check audio signal informatkm (see page 32).
Use the remote control to access and adjust each
parameter.
_.,$,._
You can change the set menu parameters while this unit is
reproducing sound.
I
Press @AMP and then press _MENIJ on
the remote control.
"BASIC SETUP" appears in the front panel display.
,,E:i:::!:iii:31(i: :iii:EUF::'
Press _A /V repeatedly and then press
_ENTER to select and enter the desired
menu.
The following menus appear in the front panel
display as you press (_)A / V repeatedly.
•i '::::Ni ii...ii"_i',ii:::'i.dii
2 :[i'.iF:'i_Ti"iiiii:i'.iLi
":i: 7d:::"T'TTd...i i',ii:::'i.dii
., .,: : .=, , _,: : : ::_,: :,_,
2
3
Press (_ A / _7to select "MANUAL SETUP".
'": "': =":" :"':" ':::_ i:::" ' T"i i i::::
,'.= =':l=..:l'.:= :=,..:l
Press _ENTER to enter "MANUAL SETUP".
"1 SOUND MENU" appears in the front panel
display.
3. :iii;OUi".!i) i0!Ei'.!U
Press _A /V repeatedly and then press
_ENTER to select and enter the desired
submenu.
• Repeat this step to navigate to and enter the items
you want to adjust.
• To return to the previous menu level, press
@RETURN.
Press (_A /_7 to select the desired parameter
and then (_<1/t> to change the parameter
value.
• Press (_)t:> to increase the value.
• Press (_)<:1 to decrease the value.
7 Press (_MENU to exit from set menu.
44
En