Yamaha OWNER'S MANUAL HTR-6130 Owner's Manual page 59

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
• General
This unit fails to turn The power cable is not connected or the Connect the power cable firmly.
on or enters the plug is not completely inserted.
standby mode soon
after the power is The speaker impedance setting is Set the speaker impedance to match your speakers. 12
turned on. incorrect.
The protection circuitry has been Make sure that all speaker wire connections on this 11
activated, unit and on all speakers are secure and that the wire
for each connection does not touch anything other
than its respective connection.
This unit has been exposed to a strong Set this unit to the standby mode, disconnect the --
external electric shock (such as lightning power cable, plug it back in after 30 seconds and then
or strong static electricity), use it normally.
No sound Incorrect input or output cable Connect the cables properly. If the problem persists, 13-17
connections, the cables may be defective.
No appropriate Audio input jack select has Set an appropriate Audio input jack select. 31
been set.
No appropriate input source has been Select an appropriate input source with 29, 30
selected. @iNPUT <:1 / C> on the front panel (or the input
selector buttons (@) on the remote control).
Speaker connections are not secure. Secure the connections. 11
The front speakers to be used have not Select the front speakers with @SPEAKERS. 29
been selected properly.
The volume is turned clown. Turn up the volume.
The sound is muted. Press @MUTE or @VOLUME +/- on the remote 30
control to resume audio output and then adjust the
vohlme.
Signals this unit cannot reproduce are Play a source whose signals can be reproduced by this --
being input from a source component, unit.
such as a CD-ROM.
Audio signals input at the HDMI jack are Make an analog or digital connection beside the
not output from any speaker terminals. HDMI connection.
The setting of the connected component is Make an appropriate setting following the instruction --
improper, manual of the connected component.
The sound suddenly The protection circuitry has been activated Check that the impedance setting is correct. 12
goes off. because of a short circuit, etc.
Check that the speaker wires are not touching each
other and then turn this unit back on.
The sleep timer has turned off this unit. Turn on this unit, and play the source again.
The sound is muted. Press @MUTE or @VOLUME +/- on the remote 30
control to resume audio output.
Sou nd is heard from Incorrect cable connections. Connect the cables properly. If the problem persists, 13-17
the speaker on one the cables may be defective.
side only.
Incorrect settings in "SP LEVEL". Adjust the "SP LEVEL" settings. 32
55 En