Yamaha OWNER'S MANUAL HTR-6130 Owner's Manual page 36

• Adjusting speaker levels during
playback
Youcan adjust the output level of each speaker while
listening to a music source.
This operation will override the level adjustment made ill "SP
LEVEL" (see page 46).
1 Press @AMP and then press @LEVEL
repeatedly to select the speaker you want to
adjust.
{:::{:4:(){..{T {.. Front left speaker
{:::'{:;?.(){".{T {:;?. Front right speaker
(.i: [:il {".{ "i" [ iil {:4: Center speaker
=.iii; W {:::'{:;?. Subwoofer
SUP.=: { ... Surround left speaker
=.i:i;U{:4'. =: { :;?. Surround right speaker
_%,-_
Once you press @ LEVELon the remote control, you can
also select the speaker by pressing @A / V.
2
Press @<:1 It> on the remote control to
adjust the speaker output level.
The control range is from -10 dB to +10 dB.
_%,._
You can press @AIBICIDIE to select a speaker and then
(_)PRESET/TLINING <1 / t> to adjust the speaker output level.
• Displaying the signal information
You can display the format, sampling frequency, channel,
bit rate and flag data of the current input signal.
Press @AMP and then press @MENU on
the remote control.
"BASIC SETUP" appears in the front panel display.
.. i:::, " "!,:::'T !"' ,:::' i:::' " r'i i i:::,
" L,,=!"i .,,,= ,;, =,,,' ....=!,,,. | =,,,= !
Press @A / _7repeatedly to select "SIGNAL
INFO" and then press @ENTER.
Press @A /_7 to switch the displayed
information.
The following information about the input source
appears in the front panel display.
Format Signal t_mmt.
Sampling
The number of samples per second taken
frequency
from a continuous signal to make a discrete
signal.
Channel The number of source channels in the input
signal (front/surronnd/LFE).
Bit rate The number of bits passing a given point
per second.
Flag data Flag data encoded in DTS, Dolby Digital,
or PCM signals that cue this unit to
automatically switch decoders.
4
Press @MENU to exit.
32
En