Yamaha OWNER'S MANUAL HTR-6130 Owner's Manual page 34

ramq,'ggqi
i!ii i:: ii =' i!:i i:iii 2_i: ii iiii i i ! _ , " = iii i " i' i:i iii:: :i: _ 2 ,,:,,"i iiii ,i_l iiiiii llllllllllllllllllllllllllI ii ii i i ii i i ii i i i i i i ii i ........
• Using your headphones
Connect a pair of headphones with a stereo
analog audio cable plug to the PHONES jack on
the front panel.
• Selecting the front speaker set
Press OSPEAKERS repeatedly to turn on or off
the set of front speakers connected to the FRONT
A or FRONT B speaker terminals.
The active front speaker set changes as follows:
-)FRONT A-----_FRONT B 1
OFF
(
When you select a sound field program, SILENT CINEMA mode
is automatically activated (see page 36).
• When you connect headphones, no signals are output at the
speaker terminals.
• All Dolby Digital and DTS audio signals are )nixed down to the
left and right headphone channels.
• Muting the audio output
Press @MUTE to mute the audio output.
Press (_)MUTE again to resume the audio output.
_%,._
• You call also rotate (_VOLUME (or press @VOLUME +/-) to
resume the audio output.
• You can adjust the muting level by using "MUTE TYP." in
"SOUND MENU" (see page 48).
• The MUTE indicator flashes in the front panel display when the
audio output is muted and disappears from the front panel
display when the audio output is resumed.
Turn off the volume level of this unit when you switch the front
speaker setting.
• Using the Zone B feature
When you set "FRONT B" to "ZONE B" (see page 45),
you can use the speakers connected to the FRONT B
speaker terminals in another room (Zone B).
Press @SPEAKERS on the front panel
repeatedly to turn on or off the Zone B speakers.
When you activate the Zone B speakers, all the speakers in
the main room are muted.
• You cannot activate both the main room and Zone B speakers
simultaneously.
• If you select CINEMA DSP sound field program and activate
the Zone B speakers, Virtual CINEMA DSP activates
automatically (see page 36).
• Selecting the component connected to
the MULTI CH INPUT jacks as the input
so u rce
Use this feature to select the component connected to the
MULTI CH INPUT jacks (see page 17) as the input
source.
Press @INPUT </b> repeatedly (or press
@AMP and then press @MULTI CH IN) so that
"MULTI CH" appears in the front panel display.
Use "MULTI CH SET" menu in "INPUT MENU" to set the
parameter for MULTI CH INPUT (see page 49).
• The input signals are amplified and output directly without
sound processing. Therefore, you cannot activate sound field
programs, the night listening )node, etc. while MULTI CH is
selected as the input source.
• When headphones are used, signals are output only from the
front left and right channels.
30
En