Ricoh M281 Series Service Manual page 382

Firmware Update
Code
36 Module error.
The program to be
downloaded does not exist on
the main unit.
The download destination
specified by the card does not
match up to the destination for
the main unit's program.
38 The version of the
downloaded program has not
been authorized for the
update.
40 Engine download fails.
41 Fax download fails.
42 Control panel / language
download fails.
43 Printing download fails.
D255/D256/M281/M282
Contents
*1
*1
*1
Solutions

Install the program to be updated in
advance.

There is a possibility that the SD card
containing the program to be updated
has not been mounted. Check to
confirm that the SD card has been
correctly mounted.

The SD card is incorrect if the program
to be updated has been correctly
installed. In this case, insert the correct
SC card.

Make sure that the program to be
overwritten is the specified version.

Switch the main power supply off and
on to try again.

If the download fails again, replace the
controller board and the BiCU.

Switch the main power supply off and
on to try again.

If the download fails again, replace the
controller board and the FCU board.

Switch the main power supply off and
on to try again.

If the download fails again, replace the
controller board and the operation
panel unit.

Switch the main power supply off and
on to try again.

The SD card media is damaged if the
update fails again. Replace the SD
card media.
5-12 SM