Fig. 6-18: Clv-Setup: Displaying The Reading Result Of The Host Interface In The Terminal Emulator With Direction Identifier At The Beginning (In This Case: O = Output) - SICK Advanced Series Operating Instructions Manual

Operating Instructions
CLV490 Bar Code Scanner
Note
8009993/RA61/2007-07-20
Operation
Displaying the data traffic of the host interface in the Terminal Emulator:
The data traffic of the host interface can be displayed in the Terminal Emulator of CLV-Setup.
Fig. 6-18 shows an example of how the reading result can be output.
1. Choose the serial interface as the external trigger source for the reading pulse.
See Chapter 6.5.1 Reading mode (standard operating mode), Page
2. Click in the toolbar.
The Terminal Emulator window is then displayed. The CLV490 is in the Reading mode.
3. Click on the SW-T
RIGGER
The red scan line then appears.
4. Present the bar code pattern from
5. Click the SW-T O
RIGGER
CLV-Setup outputs the reading result in the Terminal Emulator.
Example: "O 0123412345".
Fig. 6-18: CLV-Setup: Displaying the reading result of the host interface in the Terminal Emulator
with direction identifier at the beginning (in this case: O = Output)
If a large amount of data is being read in at high speed and with a high transmission rate,
the host interface's data trafficing may no longer be completely displayed on the auxiliary
interface (display "..."). This is due to the slower transmission rate of the auxiliary interface
(9,600 bd).
In the default setting, the CLV490 sends the following in the data output string of the host
interface:
•
On Good Read: Data content of one bar code
•
On No Read: Character string "NOREAD"
The "Header", "Code-Info/Separator", "Splitter" und "Terminator" blocks are blank.
© SICK AG · Division Auto Ident · Germany · All rights reserved
O button or press [F7].
N
Fig. 6-1, Page 6-4.
button or press [F8].
FF
Chapter 6
6-38.
6-55