Decals And Antiskid - Braun VISTA Series Installation & Service Manual

The lift is only as safe as the operator.
Lift-posted decals are shown by mounting
location. Part numbers are provided for all
decals. Inspect your lift for any missing,
worn or illegible decals. Call 1-800-THE
LIFT for replacements.
Decal and Antiskid Application Procedure
Clean powder-coated surfaces
(or painted surfaces) with
isopropyl alcohol before decal
or antiskid application. Use a
clean cloth or paper towels.
DO NOT use oily shop rags.
Wipe surface free of residue
with dry portion of cleaning
cloth.
Courtesy
Requested
Parking Courtesy
Requested
TM
"Providing Access to the World"
3" W. x 4-3/4" T.
International Corporate Hdqrs: P.O. Box 310 Winamac, IN 46996 USA
1-800-THE LIFT (219) 946-6153 FAX: (219) 946-4670
Fairfield, NJ USA Clearwater, FL USA Huntington Beach, CA USA
Oslo, Norway Kitchener, Ontario Can. Rocklea, Queensland Aust.
12375
Two Courtesy Requested decals
are supplied with all Braun lifts to
be posted on vehicle as desired.
Circuit Sentry
(100 A.) Label
Decal #18181
CAUTION! Turn RESET lever to reset breaker only!
Turning lever at any other time will result in damage.
The Braun
Rating: 100 Amps
Circuit Sentry
This unit is designed to protect the electrical system on
all Braun hydraulic wheelchair lifts. In the event of failure,
wait 60 seconds. Then turn RESET lever to reset breaker.
Actual Size:
2-3/16" W. x 15/16" T.
Supplied with 100 ampere 12 volt
Circuit Sentry #28910KS.
Page 57B

Decals and Antiskid

Decals
Mask Removal: Pay close
attention to this mask
removal procedure when
posting die-cut logo decals.
Non Lift-Posted Decals
Parking
W ARNING
Decal
#12375
Read manual before
operating lift. Call
Actual Size:
1-800-THE LIFT to
receive operator's
manual. Failure to
do so may result in
serious bodily injury
and/or property
damage. Keep
manual in lift pouch.
25674
18181
Posted on the lift
control box as shown.
To remove the masking, start
an edge and peel back slowly,
at a sharp angle directly over
the top of the decal.
Operators Warnings and
Manual
Lift Operating
Policy Instructions
Warning
Decal 28540
Decal 25674
Actual Size:
1-1/2" W. x 3-1/4" T.
W ARNING
Read manual before
operating lift. Call
1-800-THE LIFT to
receive operator's
manual. Failure to
do so may result in
serious bodily injury
and/or property
damage. Keep
manual in lift pouch.
25674
Supplied to be posted near the lift
control box mounting location (lift
posted also - see following page).
W ARNING
Replace missing, worn
or illegible decals.
Failure to do so may
result in serious bodily
injury and/or property
damage.
ADA Standee
and Interlock
Decal 19342
W ARNING
OPERATING
INSTRUCTIONS
• Read manual before operating lift.
• Load and unload on level surface
only. Read warnings and operate lift as
• Engage vehicle parking brake before outlined on LIFT OPERATING
operating lift. INSTRUCTIONS decal. Lift operating
• Provide adequate clearance outside instructions apply to wheelchair
of vehicle to accommodate lift. passengers and standees.
• Do not operate lift if you suspect lift
damage, wear or any abnormal
Standee Instructions: Standees must
condition.
stand at center of platform (fully inside
• Keep operator and bystanders clear
yellow boundaries), grip handrails and
of area in which lift operates.
lower head to clear door jamb header.
Whenever a wheelchair passenger Interlock Instructions: Lift Interlocks
is on the platform, the: vary in type and operation. Interlock
• Passenger must be positioned
(if equipped) must be operated as
fully inside yellow boundaries
instructed by transit authority.
• Wheelchair brakes must be locked
• Handrail belt must be latched 19342
• Roll stop(s) must be up
Failure to follow these rules may result
in serious bodily injury and/or property
damage.
LIFT OPERATING
INSTRUCTIONS
Note: Handrail belt must be
latched to operate lift.
OPEN DOOR(S) AND SECURE
TO UNFOLD PLATFORM:
Stand clear and press UNFOLD
switch until platform stops (reaches
floor level).
Note: In event platform does not
unfold, press FOLD switch to
release Lift-Tite™ latches.
TO UNLOAD PASSENGER:
1. Load passenger onto platform and
lock wheelchair brakes.
2. Press DOWN switch until entire
platform reaches ground level and
roll stop unfolds fully.
3. Unlatch handrail belt.
4. Unlock wheelchair brakes and unload
passenger from platform.
TO LOAD PASSENGER:
1. Load passenger onto platform and
lock wheelchair brakes.
2. Latch handrail belt.
3. Press UP switch to fold roll stop
up and raise platform to floor level.
4. Unlock wheelchair brakes and unload
passenger from platform.
TO FOLD PLATFORM:
Press FOLD switch until platform
stops. Release switch.
CLOSE DOOR(S)
U.S. Patents: 5,261,779 5,806,632
6,065,924 6,238,169 Patents Pending 28540