Fold Arm Adjustments - Braun VISTA Series Installation & Service Manual

Commercial wheelchair lift
Hide thumbs Also See for VISTA Series:
Table of Contents

Advertisement

Fold arm adjustment (length) controls the stow position of the
platform sections and the outboard roll stop (see Photo K). The
platform sections should fold together tightly and the outboard
roll stop should rotate to the vertical position when the platform
stows. Fold arms are factory set and should normally require no
adjustments.
Fold arm adjustment may affect platform angle and floor level
position. Check platform angle (see pages 26 and 27) and floor
level positioning (see pages 28 and 29A). Correct as needed
Fold Arm Adjustment
1. Remove the cotter pin inserted through the bottom
hex adjustment head. The cotter pin secures the fold
arm when properly adjusted and must be reinserted
following adjustment.
2. Turn the 1-1/8" (1.125") hex adjustment head to
adjust the length of the fold arm. Adjustments
must be 1/2 or 1 turn in order to reinsert the
cotter pin and ensure the fold arm locking slot is
aligned. Make adjustments in 180° (1/2 turn)
increments to both sides simultaneously.
Usually 1 to 1-1/2 turns is all that is needed to
rotate the roll stop from the horizontal to the
vertical position. If the original adjustment is
lost, measure the pin to pin dimension of the
fold arm assembly when the platform is at floor
level and make both sides the same. Caution:
If locking slots are not aligned, the locking tab
on the rotating slide arm will not enter the fold
arm locking slot when the lift folds resulting in
lift damage.
Shorten the length of the fold arms to loosen
the fit of the platform sections (to separate
sections).
Extend the length of the fold arms to tighten the
platform sections (to bring sections closer
together).
Caution: Do not overtighten! If too tight, lift
damage may occur.
W ARNING
Failure to align fold
arm locking slots
may result in serious
bodily injury and/or
property damage.

Fold Arm Adjustments

3. Insert the cotter pin
through the bottom
hex adjustment
head.
4. Check the platform
angle and floor level
positioning. Adjust
as needed.
Roll Stop
Hex
Adjustment
Head
Locking
Slots
Fold
Arm
Cotter
Pin
Hole
Hex
Adjustment
Head
K
Platform
sections
should fold
together
tight.
L
Cotter Pin
M
Rotating
Slide
Arm
Locking
Tab
Locking
Slot
Page 30A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vista vl917ib

Table of Contents