Control Box And Harness Installation - Braun VISTA Series Installation & Service Manual

5

Control Box and Harness Installation

Quick-Disconnect Harness: "Quick-disconnect"
hand-held controls are available with four types of
cable (standard, armored and coiled). VL917 Series
lifts are shipped without the control box harness
installed. All harnesses are equipped with the same
quick-disconnect sockets. Remove the control box
and harness from their packing and connect as
stated below.
Harness Installation (Connect) Instructions
1. Align control box harness socket guides with
pump module socket grooves (will only connect
one way).
2. Carefully insert control box harness socket in
module socket.
3. Turn control harness socket inside knurled grip
clockwise fully.
Harness Removal (Disconnect) Instructions
Reverse Steps 2 and 3 above.
Figure Q
Clip Bracket
Self-tap
Screws
Page 20
Lift Installation Instructions
Back Plate
Guide
Control Box
Harness Socket
2
3
Drill 1/8" diameter mounting holes or
use nut driver bit to install self-taps
Burr edge toward
mounting surface
Note: Position the smooth-edged surface
of back plate out (surface with burr edge
against the mounting surface).
Groove
Pump
Module
Module-mounted
9-pin Socket