Installation - Braun VISTA Series Installation & Service Manual

A
100 Amp.
Circuit
Breaker
28704
1/4-14 x 1" Washer Hex Head Self-Drilling Screws
bracket using two 1/4-14 x 1" washer hex head self-drilling
screws.
#8-18 x 3/4" wafer head self-drilling screws are supplied to
mount the circuit breaker and mounting bracket assembly.
Photos B and C depict the flush mount bracket (without
offset) mounted in the engine compartment of a Dodge van.
Two self-drilling screws mount the bracket.
Photos D and E depict the offset bracket mounted in the
engine compartment of a Ford van. One self-drilling screw
and one OEM bolt are used to mount the bracket. Mount
the bracket as needed. Check for obstructions such as
fuel lines, coolant lines, wires, exhaust, etc. before drilling.
Remove the rubber caps attached to circuit breaker termi-
nals. Attach the lift power cable to the Auxiliary terminal of
the Circuit Sentry. Attach one end of the battery lead cable
to the Circuit Sentry Battery terminal. Tighten securely.
Reposition the rubber caps onto the breaker terminals to
prevent electrical short circuits. Carefully connect the
opposite end of the battery lead cable to the Positive (+)
post of the battery.
Post decal 18181
adjacent to the
Circuit Sentry
assembly (provides
circuit breaker reset
instructions). Note:
Clean the surface
with isopropyl
alcohol before decal
application. Use a
clean cloth or paper
towels. DO NOT
use oily shop rags.
Wipe surface free of
residue with dry
portion of cleaning
cloth.
Lift Installation Instructions
Flush Mount
Bracket
28755
#8-18 x 3/4" Wafer Head
Self Drilling Screw
D
Decal 18181
Mount the circuit breaker to the mounting bracket.
Four .191" diameter holes spaced 1" apart are
provided in each mounting bracket. The holes
match the pattern of circuit breaker mounting holes.
Place the bracket securely in a vice gripping the
edge that does not obstruct positioning of the circuit
breaker (see Photo A). Mount the breaker to the
Dodge Van Installation
#8-18 x 3/4" Wafer Head Self Drilling Screws
Attach lift (or other device) power cable
to Circuit Sentry Auxiliary terminal.
Attach battery lead cable to
Circuit Sentry Battery terminal.
Attach power cable to Circuit
OEM Bolt Sentry Auxiliary terminal.
Ford Van Installation
Attach battery lead cable to
Circuit Sentry Battery terminal.
B
C
E
Page 19