Table of Contents
Advertisement
Lock/Unlock Tare
1. Press
>>
2. Press
MENU
3. Press
Scale functions
4. Press
Lock
Locked Tare displays briefly in the indicator message cell.
3.4
Weighing Procedure
The Load Ranger Wheel Weigh Pads can be arranged in wheel-weighing systems with up to fourteen weigh pads and axle-
weighing systems with only two weigh pads. This section highlights the differences between the two systems.
3.4.1
Wheel-Weighing System
A wheel-weighing system consists of as many platforms as there are vehicle wheels to be weighed. This method allows the
user to weigh the whole vehicle in a single step. The Ai-1 indicator display simultaneously shows the weight of single wheels,
axles and the total gross or net weight. The Ai-1 indicator also has the ability to show the center of gravity coordinates if setup
correctly
(Section 4.3 on page
Wheel-Weighing Procedure
1. Assign ID numbers to the wheel weigh pads
pads
(Section 3.2.1 on page
2. Position the wheel weigh pads
3. Select the vehicle to be linked to the weigh if necessary
4. Perform a full scale zero
5. Position vehicle onto the platforms.
6. Press
M+
• If weight is captured correctly the indicator executes the printout for the weight of each wheel and axle, if configured.
• If the scale is unable to capture the weight (example: due to instability) a prompt displays.
Press
Yes
7. Press
TOTAL
8. Remove the vehicle from the platforms.
to switch the indicator display to the secondary weigh screen.
.
.
100
. Display returns to the secondary weigh screen. Unlocked Tare or
/
Unlock Tare
105
33).
Figure 3-13. Wheel-Weighing System
(Section 3.1.3 on page
15).
(Section 2.2 on page
(Section 3.3.1 on page
, once weight is stable.
to attempt weighing again or press
to execute the printout of the total weight, minus the tare value if needed.
13) and pair Ai-1 indicator with the wheel weigh
5).
(Section 3.7.4 on page
18).
to cancel the weigh.
No
© Rice Lake Weighing Systems ● All Rights Reserved
Operation
23).
19
Advertisement
Table of Contents
