Set Up The Printer Using The Printer Default Ip Address - Emerson Micro Motion 5700 Installation Manual

Installation Manual
MMI-20029768
8. Perform a test print to verify the settings are correct.
If needed, see Function Check Failed in the Status alerts, causes, and recommendations
section of the Micro Motion 5700 with Ethernet Transmitters: Configuration and Use Manual.
6.2 Set up the printer using the printer default IP
address
Use this procedure to set up printing with a 5700 Ethernet transmitter and an Epson TM-
T88VI printer using the printer's default IP address.
Procedure
1. Connect one end of an Ethernet cable and power supply to the printer.
2. Connect the other end of the Ethernet cable to the PC.
3. Power on the printer.
4. Turn off DHCP if it is enabled.
5. Configure the IP address.
Installation Manual
Display
ProLink III
Web browser
For instructions on how to configure print ticket options, see the Micro Motion 5700
with Ethernet Transmitters: Configuration and Use Manual.
It can take 1-2 minutes for the printer to finish configuring network settings. When
complete, the following ticket prints.
*********************************
IP Address : 192.168.192.168
SubnetMask : 255.255.255.0
Gateway : 0.0.0.0 DHCP : No server - > Static
*********************************
From the display
a. Go to Menu → Configuration →
Ethernet Settings → Network Settings
→ Auto obtain IP()DHCP.
b. Select Disabled and Save.
c. Back out to the Ethernet Settings page
to apply the DHCP off setting.
Menu → Operations → Printer → Print Ticket → Print Test
Page
Device Tools → Configuration → Printer and Tickets
Configuration → Printer and Tickets
From ProLink III
a. Go to Device Tools → Configuration →
Network Settings.
b. Uncheck Obtain an IP address
automatically (DHCP).
c. Select Apply.
Set up the printer
March 2020
43