Set Up The Printer; Set Up The Printer By Changing The Printer Default Ip Address - Emerson Micro Motion 5700 Installation Manual

Installation Manual
MMI-20029768
6

Set up the printer

Use this section to set up printing with a 5700 Ethernet transmitter and an Epson TM-
T88VI printer. For information on configuring the printer, see Micro Motion 5700 with
Ethernet Transmitters: Configuration and Use Manual.
There are two ways to set up printing:
• Use the printer's default IP address
• Change the printer's default IP address
6.1 Set up the printer by changing the printer
default IP address
Use this procedure to set up printing with a 5700 Ethernet transmitter and an Epson TM-
T88VI printer by changing the printer's default IP address.
Procedure
1. Connect one end of an Ethernet cable and power supply to the printer.
2. Connect the other end of the Ethernet cable to the PC.
3. Power on the printer.
4. Temporarily change the Ethernet address for the PC so that the Ethernet is on the
5. Change the printer firmware options.
Installation Manual
The printer IP address prints after a few minutes.
same subnet as the printer:
Default IP address = 192.168.192.168
a) From Windows 10, right-click the Start button and select Network
Connections.
b) Right-click the Ethernet connection and select Properties.
Select Yes on any user account pop-up windows.
c) Select Internet Protocol Version 4(TCP/IPv4), then select properties.
d) Select Use the following IP address and configure the IP address and subnet
mask as follows:
• IP address: 192.168.192.x, where x is something other than 0, 1, or 168
• Subnet mask: 255.255.255.0
e) Select OK.
a) Open your web browser and type http://192.168.192.168 (default
printer IP).
The browser displays, Your connection is not private . Ignore the
warning and proceed to the website.
Set up the printer
March 2020
41