Rotate The Sensor Wiring Junction Box On A Remote-Mount Transmitter (Optional) - Emerson Micro Motion 5700 Installation Manual

Mounting and sensor wiring
March 2020
9. Place the display cover onto the main enclosure.
10. Turn the display cover clockwise until it is fully seated.
11. Replace the end-cap clamp by tightening the cap screw.
12. Restore power to the transmitter.
3.7 Rotate the sensor wiring junction box on a
remote-mount transmitter (optional)
In remote-mount installations, you can rotate the sensor wiring junction box on the
transmitter plus or minus 180º.
Procedure
1. Using a 4 mm hex key, loosen and remove the clamp securing the sensor wiring
2. Gently rotate the junction box to the desired position.
26
junction box in place.
Figure 3-18: Removal of the clamp
You can rotate the junction box plus or minus 180º to any position.
Figure 3-19: Rotation of the sensor wiring junction box
Installation Manual
MMI-20029768
Micro Motion 5700 Ethernet Transmitters