Table of Contents
Advertisement
Mounting and sensor wiring
October 2022
7. Gently press the display module back onto the connector.
8. Tighten display screws.
9. Place the display cover onto the main enclosure.
10. Turn the display cover clockwise until it is fully seated.
11. Replace the end-cap clamp by tightening the cap screw.
12. Restore power to the transmitter.
3.7
Rotate the sensor wiring junction box on a
remote-mount transmitter (optional)
In remote-mount installations, you can rotate the sensor wiring junction box on the
transmitter plus or minus 180º.
Procedure
1. Using a 4 mm hex key, loosen and remove the clamp securing the sensor wiring
2. Gently rotate the junction box to the desired position.
22
junction box in place.
Figure 3-16: Removal of the clamp
You can rotate the junction box plus or minus 180° to any position.
Micro Motion 5700 transmitters for F
Installation Manual
MMI-20029969
Fieldbus
OUNDATION
Advertisement
Table of Contents
