Water Supply; Electricity Supply - Lavor Tormenta Translation Of The Original Instructions

avoid damage, it must be handled with special
care. Misuse may lead to premature breakages
or damage and cause the loss of warranty cov-
er.
•
WARNING: The appliance is not to be used
by children or persons with reduced physical,
sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been
given supervision or instruction.
•
WARNING: Children being supervised not to
play with the appliance.
•
WARNING: Never start the high-pressure
cleaner without first completely unwinding
the high-pressure hose.
•
WARNING: When winding and unwinding the
pipe take care not to cause the high-pressure
cleaner to overturn.
•
WARNING: Before unwinding or winding the
hose, switch the machine off and release the
pressure in the hose itself (switching off).
>

WATER SUPPLY

Water supply collection
Caution - Danger!
Only clean or filtered water should be used for in-
take. The delivery of the water intake tap should be
equal to the double of the maximum pump range.
- Minimum delivery rate: 15 l/ min.
- Maximum intake water temperature: 40°C
- Max inlet water pressure: 1Mpa
Place the cleaner as close to the water supply system
as possible.
Water supply from the water main
• Connect a supply hose (not included) to the water
inlet of the unit and to the water supply.
• Open the water supply.
The cleaner can be connected directly to the mains
drinking water supply hose is fitted with a backflow
preventer valve as per current regulations in force.
Make sure that the hose is at least Ø 13mm and that
it is reinforced.
Water supply from an open container
• Unscrew the coupling part for the water inlet.
• Screw the suction hose with filter (not included)
onto the water connection of the unit.
• Hang the filter in the container.
• Vent the unit before operation.
- Unscrew the high-pressure line at the high-pres-
sure outlet of the unit.
- Switch on the unit and let it run until water free
of bubbles emerges at the high-pressure outlet.
- Switch off the unit and screw on the high-pres-
sure hose again.
Failure to comply with the above conditions causes
serious mechanical damage to the pump and the
loss of warranty cover.
>

ELECTRICITY SUPPLY

- The appliance's electrical connection must
comply with the IEC 364 standard.
Before connecting the appliance, make sure
that the nameplate data are the same as those
of the electrical mains and that the socket is
protected by a differential security breaker with
tripping sensitivity below 0.03 A - 30 ms.
- If the appliance's plug is not compatible with
the socket, have the socket replaced with an-
other of suitable type by professionally quali-
fied staff.
- Never use the appliance in ambient tempera-
tures below 0° C if it is equipped with a PVC (H
VV-F) cable.
•
WARNING: Inadequate extension cords can be
dangerous.
- If an extension lead is used, the plug and socket
must be watertight and the cable must have
the dimensions shown in the table below.
Plug
HOW TO CONNECT THE CORD TO A U.K. PLUG: IM-
PORTANT
The wires in the mains lead are coloured in accor-
dance with the following code:
Blue
Brown
Yellow/Green
Please read the instructions given below before con-
necting the cord to a plug. If in doubt please consult
a qualified electrician. As the colours of the wires in
the mains lead of this appliance may not correspond
with the coloured markings identifying the termi-
nals in your plug, proceed as follows:
The wires that is coloured Brown must be connected
to the terminal which is marked with the letter L or
coloured Red. The wire that is coloured Blue must be
17
EN
Neutral
Live
Earth